Safety notice

Please read this before giving a clicker to a child.

⚠ WARNING: CHOKING HAZARD — Small parts.

Not for children under 3 years. Recommended for ages 5 and up with adult supervision.

What's inside

Each kit contains a 3D-printed board, mechanical keyboard switches, press-fit printed keycaps and a metal keychain ring or lanyard clip. Keycaps and switches are small parts that can be removed with force.

Before use

Check that every keycap and switch is firmly seated. Stop use if any part becomes loose, cracked or damaged.
Keep away from children under 3 and from pets.
Lanyards and chains can pose a strangulation risk for young children — never leave a child unattended with a lanyard around the neck.
Keep away from open flame and heat sources; PLA plastic softens above 60 °C (a hot car in summer).

Materials

Boards and keycaps are printed in PLA filament. Switches are standard mechanical keyboard switches. No batteries, magnets or liquids.

Regulatory

TwoLittlePrints products are designed with the Canada Consumer Product Safety Act and the Toys Regulations (SOR/2011-17) in mind, including the small-parts requirements for toys. A full compliance statement and test summary will be published on this page before launch. Questions: hello@twolittleprints.com.